Introduction:
Welland portable media enclosure - ME820AO, provides friendly interface to help users upgrading embed firmware to fix the compatibility problems via TV in the field. Please check the following operating procedures:
USB OTG Firmware Upgrade :
STEP-1
(a)First of all, you should down load the latest released application tool with firmware from Welland's website.
(b)Change the switch to Host Mode. Press the
"copy" button then plug in USB cable to connect with your computer. (Note: please do not release button until this device is powered up.) Please also check the below figure.
(c)
You can find your ME820AO has already been recognized by PC as a "removable disk" on the windows explorer (As below figure). That means " ME820AO" has already been into "upgrading mode".
You can find your ME820AO has already been recognized by PC as a "removal disk" on the windows explorer (As below figure). That means " ME820AO" has already been into "upgrading mode".
STEP-2
Extract the
Enduser .zip that you downloaded from Welland's website to a folder. Double click on "EndUser.exe" in the folder, the screen will show as following. Click on "Download" item.
STEP-3
After the download process was completed & success, please just lick "OK" to close this windows.
STEP-4
Power off/on and re-plug your ME820AO once again, then all firmware upgrading procedures were completed.
